Ethio Construction Engineering

👍10❤3

5.78K views08:03

👉Here are 50 points for a Construction engineering field expert

1. Unit weight of steel is 7850 kg/m³.
2. Height of the wall is 4m.
3. Unit weight of concrete is approximately 2400 kg/m³.
4. Standard brick size is 190mm x 90mm x 90mm.
5. Compressive strength of M20 concrete is 20 MPa.
6. Slump test measures the workability of concrete.
7. The minimum curing period for concrete is 7 days.
8. Shear force and bending moment diagrams are used to analyze beam loads.
9. The modulus of elasticity of steel is 200 GPa.
10. Water-cement ratio affects concrete strength and durability.
11. Effective span of a beam is the distance between centers of supports.
12. The permissible stress in mild steel (Fe250) is 250 MPa.
13. Dead load includes the self-weight of structural elements.
14. Live load includes the weight of occupants and movable objects.
15. The maximum deflection limit for beams is L/250.
16. Reinforced concrete design follows the principles of limit state design.
17. Young’s modulus of concrete ranges from 25 to 35 GPa.
18. The coefficient of thermal expansion of concrete is 10-6 /°C.
19. In RCC, tensile strength is provided by steel reinforcement.
20. Shear reinforcement is provided in the form of stirrups.
21. Clear cover for rebar in beams is typically 25mm.
22. Clear cover for rebar in slabs is typically 20mm.
23. Standard consistency of cement paste is about 30%.
24. The fineness modulus of fine aggregate ranges from 2.2 to 3.2.
25. The Poisson's ratio for steel is approximately 0.3.
26. The unit weight of water is 1000 kg/m³.
27. Specific gravity of cement is around 3.15.
28. The initial setting time of ordinary Portland cement is 30 minutes.
29. The final setting time of ordinary Portland cement is 10 hours.
30. Slump values for structural concrete typically range from 75 to 125 mm.
31. Maximum size of coarse aggregate in RCC is 20mm.
32. The tensile strength of concrete is approximately 10% of its compressive strength.
33. The allowable bearing capacity of soil should be determined through soil tests.
34. Plate load test is used to determine the bearing capacity of soil.
35. Permeability of soil affects the design of foundations and drainage systems.
36. Standard penetration test (SPT) assesses soil compaction and bearing capacity.
37. The unit weight of sand is approximately 1600 kg/m³.
38. Soil compaction increases the bearing capacity of soil.
39. Angle of repose indicates the stability of granular materials.
40. Cohesion is a measure of the shear strength of cohesive soils.
41. A cantilever beam is fixed at one end and free at the other.
42. Fixed-end moments are moments developed at fixed supports.
43. Bending stress in a beam is calculated using the formula σ = My/I.
44. Torsion in beams is caused by twisting moments or torques.
45. A simply supported beam has supports at both ends.
46. The moment of inertia of a rectangular section is bd³/12.
47. Deflection in beams can be calculated using integration methods.
48. Reinforcement bars should be free of rust and other contaminants.
49. Development length is the length required to transfer stress to concrete.
50. Hooked bars are used to anchor reinforcement in concrete.

@etconp

👍26❤3👏3

6.38K views11:03