Forwarded from Doomsday Tradecraft
How do you make a wire antenna directional?
A plain long wire talks in two directions at once — forward to whoever you're working, and backward to everyone behind you. You can't rotate it and you can't switch off the back lobe. But you can absorb it.
Here's why it happens. Power runs up the wire, reaches the open far end, and has nowhere to go, so it reflects and travels back — radiating the whole way. That returning wave is the rear lobe.
The fix is a resistor. Connect the far end to ground through a 500 to 600 ohm non-inductive resistor. The forward wave still radiates all the way down the wire; whatever is left at the end gets absorbed instead of reflected. Nothing travels back, so nothing radiates rearward.
The trade is better than it sounds. On a five-wavelength wire at 14 MHz, terminating cuts rearward radiation by roughly 15 dB and costs about 2 dB forward. Shorter wires pay more — a two-wavelength V-beam gives up around 3.5 dB. And the power heating that resistor is power that would have gone backward anyway.
Component choice matters more than people expect. Wirewound resistors are useless here — the winding behaves as a coil at RF. Carbon types are electrically fine but handle only a few watts, so QRP only. Whatever you use needs a rating of half your transmitter output, short leads, and a weatherproof box at the far end. A useful trick: three resistors in series instead of one reduces stray capacitance.
Build notes: one wire, two wavelengths or longer, 3 to 7 metres up, as straight as the ground allows. Good ground at both ends. Below 12 MHz, point the terminated end straight at the distant station.
Save this for your comms binder.
Send it to someone whose wire antenna hears everything from everywhere.
Full comms course on the profile.
#hamradio #radio #antenna #army #recon
A plain long wire talks in two directions at once — forward to whoever you're working, and backward to everyone behind you. You can't rotate it and you can't switch off the back lobe. But you can absorb it.
Here's why it happens. Power runs up the wire, reaches the open far end, and has nowhere to go, so it reflects and travels back — radiating the whole way. That returning wave is the rear lobe.
The fix is a resistor. Connect the far end to ground through a 500 to 600 ohm non-inductive resistor. The forward wave still radiates all the way down the wire; whatever is left at the end gets absorbed instead of reflected. Nothing travels back, so nothing radiates rearward.
The trade is better than it sounds. On a five-wavelength wire at 14 MHz, terminating cuts rearward radiation by roughly 15 dB and costs about 2 dB forward. Shorter wires pay more — a two-wavelength V-beam gives up around 3.5 dB. And the power heating that resistor is power that would have gone backward anyway.
Component choice matters more than people expect. Wirewound resistors are useless here — the winding behaves as a coil at RF. Carbon types are electrically fine but handle only a few watts, so QRP only. Whatever you use needs a rating of half your transmitter output, short leads, and a weatherproof box at the far end. A useful trick: three resistors in series instead of one reduces stray capacitance.
Build notes: one wire, two wavelengths or longer, 3 to 7 metres up, as straight as the ground allows. Good ground at both ends. Below 12 MHz, point the terminated end straight at the distant station.
Save this for your comms binder.
Send it to someone whose wire antenna hears everything from everywhere.
Full comms course on the profile.
#hamradio #radio #antenna #army #recon
❤5👍1